Replacing a METO Ink Roller in Your METO Pricing Gun

Change the Ink Roller on Your METO Gun

Written Instructions:

Step 1:  Press and hold the trigger; this will expose the ink roller holder (grey part) at the front of the pricing gun. The ink roller bracket (the part which holds the ink roller holder) will appear, 

Step 2: Pull the ink roller section further out with your fingers until it clicks into place. This will allow you to release the trigger.

Step 3: Glide and remove the grey ink roller holder from the ink roller assembly.

Step 4: Squeeze the serrated ends of the grey ink roller holder from both sides. This will allow the old ink roller to ‘pop’ out.

Step 5: Keep the new ink roller in the packaging, carefully slice the foil packaging open and clip the grey ink roller holder onto the new ink roller whilst it is still in the packaging.

You should hear and feel each end of the ink roller snap into place at the ends of the ink roller holder.

Step 6: Once the ink roller is in the ink roller holder, slide the ink roller holder back onto the ink roller assembly at the front of the gun. (Ensure that the grey ink roller holder is pushed all the way into the home position.)

Step 7: Once the ink roller is in place, push the ink roller assembly into the gun.