Replacing a label roll in a large METO 1829 & 3329 pricing gun

Replace the Label Roll in the METO 1829 & 3329 Pricing Gun

Written Instructions:

Step 1: Get a new roll of labels and remove the first whole layer that goes around the roll, and discard these labels.

Step 2: Tear the backing paper off square with the label, but don’t remove the labels from the backing paper. 

Step 3: To help guide the roll of labels through the gun, it helps to make a slight fold lengthways at the very beginning of the roll. This will make it easier for the labels to thread through the gun to come out the other side.

Step 4: Open the base with the two side slides.

Step 5:  With the labels facing upwards, thread the tail of the roll through that big gap between the application roller and the base plate in the gun.

Step 6: Fit the roll into the roll holder.  If you find it hard to fit the roll in, you will need to slightly prise apart the ends. (Ensure the roll spins freely after fitting.)

Step 7: Pull out approximately 20 cm of the label roll and leave the labels on the backing paper.

Step 8: Close the base & feed the labels perpendicular into the transport unit.

Step 9: Whilst squeezing the trigger repeatedly, push the perpendicular labels into the opening at the same time until the labels grab and appear at the bottom of the gun.